SE E15i после разблокировки стал кирпичом, использовал Dreambox server client.
До этого востанавливал Riffom аналогичные модели, Нет вибрации, не видит по usb, думаю boot не восстанавливается.
вчем может быть проблемма?
лог:
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.32, JTAG Manager Version: 1.43
Selected Resurrector: [SE E15i V1.0.4463.41118]
Connecting to the dead body...OK
Detected dead body ID: 0x203C00E1 - CORRECT!
Set I/O Voltage reads as 2.61V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected an Initialized FLASH1 Chip, ID: 0x00EC/0x55BC (512MB)
Selected Resurrection Data for the NAND Chip with Page size = 2KB
Preparing data. Please wait...OK
Flashing the dead body...OK
Resurrection complete!
До этого востанавливал Riffom аналогичные модели, Нет вибрации, не видит по usb, думаю boot не восстанавливается.
вчем может быть проблемма?
лог:
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.32, JTAG Manager Version: 1.43
Selected Resurrector: [SE E15i V1.0.4463.41118]
Connecting to the dead body...OK
Detected dead body ID: 0x203C00E1 - CORRECT!
Set I/O Voltage reads as 2.61V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected an Initialized FLASH1 Chip, ID: 0x00EC/0x55BC (512MB)
Selected Resurrection Data for the NAND Chip with Page size = 2KB
Preparing data. Please wait...OK
Flashing the dead body...OK
Resurrection complete!