Лог z3x easy
EasyJtag Suite ver.: 1.6.1.4 / wxWidgets 3.1.0-W-U started.
Operating system ver.: Windows XP (build 2600, Service Pack 3).
For support and updates visit
Check security...OK
Initialising: HTC DESIRE X DUAL PM661100 Config ver.:1.00
I/O Level set to : 2200 mV
Box S/N: ,FW Ver.: 01.50
Connecting to Target...
JTAG device: MSM8225
CPU IDCODE : 0x007700E1 Mfg.: 0x070, Part: 0x0770, Ver.: 0x0
CPU Manufacturer: QUALCOMM , CPU Name: MSM8225 Rev 1.0
Halting CPU...
Initialize hardware...
Starting target communication...
Detecting emmc memory parameters of bank (0) ...
embeddedice handshake timeout
Timeout Error while reading approx : 0x00000008 bytes over DCC
ERROR: No loader answer
DCC Loader init Failed!
BUG: emmc unknown controller initialization failure
лог Riff
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.56
Selected Resurrector: [HTC Proto (PM6610000) V1.0.5019.4693]
Connecting to the dead ************...OK
Detected dead ************ ID: 0x007700E1 - CORRECT!
Set I/O Voltage reads as 2.61V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
WARNING: DCC Loader was unable to initialize FLASH1 chip. Error code: 0x02010035
ERROR: Selected FLASH Chip was not initialized by the DCC Loader.
Флешку под замену?
