Huawei Matepad T 10 AGRK-W09 Huawei iDРешено 

  • Автор темы Автор темы muschka
  • Дата начала Дата начала
18/1/08
32
0
0
45
0
Здравствуйте столкнулся с такой проблемой на Huawei Matepad T 10 при снятии Octoplus Huawei 1.3.4 не переводит устройство из Factory Mode в adb режим.

Job ID: 0000000001F691B2
2024-02-21 09:22:00
Starting Reset Huawei ID
Selected phone model: ‪PPA-LX2‬
Warning: Please, make sure the phone`s battery is fully charged and connected, after connect the device via Factory Mode (use Hardware Test Point or "ON/OFF Factory Mode option").
Warning: Selected response: Proceed
Searching HUAWEI USB COM 1.0 port...
Detected ‪HUAWEI USB COM 1.0‬ port
Phone connect successfully
Writing bootloader KIRIN710A_V3...
Initializing remote service connection...
Writing ‪XLOADER‬ partition...
Writing ‪UCE‬ partition...
Writing ‪FASTBOOT‬ partition...
Operation in progress. Please wait for instructions...
Bootloader Update successfully
Rebooting to fastboot mode...
Warning: If you use modified USB cable please reconnect cable from the mother board and press "Ok" to proceed the operation
Warning: Selected response: Ok
Searching Fastboot devices...
Error: Fastboot devices not found
Reset Huawei ID failed.
Performed by ‪1.3.4‬ Software version.
 
Error: Fastboot devices not found

Драйвера стоят?
 
В Фаствоот перезагрузился? Я спрашиваю про драйвера фастбоот 1.4.3 допустим.
 
Если в ручную перевожу выход вот такое.
Job ID: 0000000001F69218
2024-02-21 09:25:38
Starting Reset Huawei ID
Selected phone model: ‪PPA-LX2‬
Warning: Please, make sure the phone`s battery is fully charged and connected, after connect the device via Factory Mode (use Hardware Test Point or "ON/OFF Factory Mode option").
Warning: Selected response: Proceed
Searching HUAWEI USB COM 1.0 port...
Detected ‪HUAWEI USB COM 1.0‬ port
Phone connect successfully
Writing bootloader KIRIN710A_V3...
Initializing remote service connection...
Writing ‪XLOADER‬ partition...
Writing ‪UCE‬ partition...
Writing ‪FASTBOOT‬ partition...
Operation in progress. Please wait for instructions...
Bootloader Update successfully
Rebooting to fastboot mode...
Warning: If you use modified USB cable please reconnect cable from the mother board and press "Ok" to proceed the operation
Warning: Selected response: Ok
Searching Fastboot devices...
Found android device: W7HYD22730601096
Detected ‪Android Sooner Single ADB Interface‬ port
Reading basic data...
Device Model: ‪AGRK-W09‬
System: ‪AGRK-W29 10.1.0.112(C10E10R1P1)‬
Base Version: ‪AGRK-LGRP10-OVS 10.1.0.112‬
Custom Version: ‪AGRK-W29-CUST 10.1.0.10(C10)‬
Preload Version: ‪AGRK-W29-PRELOAD 10.1.0.1(C10R1)‬
C_Version: ‪C10‬
D_Version: ‪D000‬
FB Lock State: ‪LOCKED‬
User Lock State: ‪LOCKED‬
Downloading resource...
Connecting to the credit server...
Username: Default_user
Checking balance...
Your balance: 1 credits
Sending device information...
Sending firmware information...
Error: Bootloader check failed. Connect your phone via Factory mode and perform the operation again.
Reset Huawei ID failed.
Performed by ‪1.3.4‬ Software version.
 
Хорошо сейчас переустановлю снова драйвера.
 
Решил вопрос покупкой Chimera Tool загоняем в fastboot устройство определяется выбираем Selected phone model: ‪PPA-LX2‬ выбираем меню сброс frp делаем testPoint
AVvXsEhKzf5iqbweGl9exiFLlO4N1pt1o7xI8gieH3TSVj_QINtRsWHztgRFtAzRbJBGaWNsWrA2fVWtor_GDWtoEbfUg91IN_gi1vNPjHiQjJRCt0TTkpyC2cNfLrE8TrSXrSLfhTuhSuBMIZ8gqAMe0UxF7ky1MH8DLT-eSpxXaCKdRBPdRYtHJjSNIjM5=w345-h640-rw
благодарю всех за помощь.
 
Назад
Верх Низ