Samsung i9023 Восстановление Jtag
в мануале по восстановлению i9023 написанно:
Current resurrector has two different versions of primary boot loaders (PBL) embedded. This depends on hardware version of your phone which boot to use, thus in case of failure (cannot enter download mode after resurrection) of first loader try selecting another
После восстановления (настройки по умолчанию)
Код:
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.27, JTAG Manager Version: 1.36
Selected Resurrector: [Samsung I9023]
Connecting to the dead body...OK
Detected dead body ID: 0x1BA00477 - CORRECT!
Set I/O Voltage reads as 2.79V, TCK Frequency is 8 MHz
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected an Initialized FLASH1 Chip, ID: 0x00EC/0x0050 (512MB)
Flashing the dead body...OK
Resurrection complete!
телефон не входит в режит download...
Собственно вопрос, Как поменять тот самый загрузчик?
Ето попробуй может подойдёт!
