собственно имеется трубка s5830, была труп, восстановил бут и прошил родным софтом, телефон завёлся но еомерок все нули, решил влить в него фулл. родной слился без проблем, потом erase, и теперь или
Connecting to the dead body...OK
Detected dead body ID: 0x303C10E1 - IGNORED!
Set I/O Voltage reads as 2.59V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at 20 kHz]
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected a Not Initialized FLASH1 Chip ID: 0xAAAA/0xAAAA (256MB)
Detected a Not Initialized FLASH2 Chip ID: 0xAAAA/0xAAAA (256MB)
ERROR: Selected FLASH1 Chip was not Recognized by the DCC Loader. Terminating.
или
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.26, JTAG Manager Version: 1.32
Selected Resurrector: [Samsung S5830]
Connecting to the dead body...OK
Detected dead body ID: 0x303C10E1 - CORRECT!
Set I/O Voltage reads as 2.59V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...FAILED
ERROR: No response from the RIFF Box.
Не пойму где грабли, ведь до стирания всё коннектилось и восстанавливалось.
Connecting to the dead body...OK
Detected dead body ID: 0x303C10E1 - IGNORED!
Set I/O Voltage reads as 2.59V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at 20 kHz]
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected a Not Initialized FLASH1 Chip ID: 0xAAAA/0xAAAA (256MB)
Detected a Not Initialized FLASH2 Chip ID: 0xAAAA/0xAAAA (256MB)
ERROR: Selected FLASH1 Chip was not Recognized by the DCC Loader. Terminating.
или
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.26, JTAG Manager Version: 1.32
Selected Resurrector: [Samsung S5830]
Connecting to the dead body...OK
Detected dead body ID: 0x303C10E1 - CORRECT!
Set I/O Voltage reads as 2.59V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...FAILED
ERROR: No response from the RIFF Box.
Не пойму где грабли, ведь до стирания всё коннектилось и восстанавливалось.